Listening To A Cd - Innovative Technology ITVS-325 Instruction Manual

Important:
‐ Closing the top cover will help prevent dust from settling on the turntable.
‐ Always relock the tone arm clip before transporting the unit.
‐ Do not place anything on top of the turntable cover, especially while playing a record.
4. Press the OPEN/CLOSE ( ) button to close the tray.
5. Press the PLAY/PAUSE button (
6. To temporarily pause playback, press the PLAY/PAUSE button (
7. To skip tracks forward or backward, press the corresponding skip button (
one will restart the current track. Pressing
previous track.
8. To fast forward / rewind within a track, press and hold down the corresponding skip button until the
desired position is reached.
9. To stop playback, press the STOP
Note: CD playback will automatically begin if a CD is already in the disc tray before the unit is switched to
the CD function.
Important:
‐ Never place more than one disc on the tray.
‐ The disc must be placed in the center of the disc tray. An incorrectly loaded disc can permanently damage
the tray door mechanism.
‐ Do not push the CD tray – always use the OPEN/CLOSE button.
‐ It takes a moment for the unit to load a disc, during which all buttons will be temporarily deactivated.
Repeat Playback / Programmed Playback
Each time the PLAY MODE button is pressed, the repeat mode will cycle through the following options:
REPEAT 1 (Repeat one track)
The current track will be played repeatedly. If you press the (
the track you select will be played repeatedly.
REPEAT ALL (Repeat the entire CD)
The entire CD will be played repeatedly.
Notes:
‐ If one of the following buttons is pressed, the repeat mode will be cancelled.
OPEN/CLOSE, POWER, or rotate the FUNCTION knob to FM, AM or PHONO position.
‐ Repeat playback works with finalized discs only.
Programmed Playback
Up to 20 tracks can be programmed to play in the desired order.
Note: Programmed playback works with finalized disc only.
LISTENING TO A CD
) to begin playback.
button
1. Rotate the FUNCTION knob to the "CD" position (1).
"‐ ‐" will blink for a few seconds.
Note: When no disc is set, "NO" will appear on
the display.
2. Press the OPEN/CLOSE ( ) button (2).
3. Place a disc on the tray with the printed label
face up.
). Press
twice in succession will return to the beginning of the
or
7
again to resume.
or ). Pressing
) button to select another track,