Pedelec Mode And Assist Mode - Wisper 806 Classic 2013 Owner's Manual

3.4 Pedelec mode and ASSIST mode

3.4.1 When you first ride your 806Classic you will notice that after half to one turn of the pedals
the motor will start working assisting you ride the bike by adding power to the front wheel. This is
the standard or pedelec mode. To continue using the pedelec mode you must keep turning the
pedals, if you stop pedaling the motor will stop and the bike will slow to a halt. If you start pedaling
again after half to one turn the motor will start again.
3.4.2 You will find the ASSIST level shows on the LCD display. You can adjust the assistance
strength by pressing the up or down arrow.
There are 6 levels of assistance. 40%/50%/60%/80%/90%/100% and zero assistance. The image
below shows level 6 selected.
3.4.3 80%, 90% and 100% mode are generally used when you need a greater amount of assistance
from the motor. 60% mode is used when you do not need the instant power of 90% or 100%. 40%
and 50% are used in high traffic situations or poor conditions such as ice and snow when 80%, 90%
and 100% power immediately could be dangerous.
3.4.4 Power consumption. When you increase the assistance, you will find the battery range is
reduced. Further details on this are included later in this manual in Appendix 2.
3.4.5 Zero assistance mode: In this mode there will be no assistance from the motor but the
speed, distance and time displays on the LCD display will continue to operate as normal as will the
lights.
16