Table of Contents
Advertisement
10.2
The LIGHT button can be found close to the ON/OFF button. If you press it when the bike
power is on, the LED headlight and rear light will illuminate. Press it again to switch off the lights.
The power for the lights comes from the bike battery, but due to a low power consumption of the
lights, you will not noticeably reduce your range.
3.3 The Throttle
3.3.1
The twist grip throttle can be found on the left hand side of the handlebars. Further details
of the operation are provided below.
3.4 Pedelec mode and ASSIST mode
3.4.1
When you first ride your Wisper bike, you will notice that after half to one turn of the
pedals, the motor will start working assisting the bike by adding power to the back wheel. This is the
standard or pedelec mode. To continue using the pedelec mode you must keep turning the pedals, if
you stop pedaling the motor will stop and the bike will slow to a halt. If you start pedaling again,
after half to one turn the motor will start again.
3.4.2
You will find the ASSIST buttons (marked with a
with six associated LEDs (small red lights). Each time the
sequentially ranging between one and six and the corresponding power level in pedelec mode
increases in increments of 20%. Setting six provides 100% power. For safety reasons the default level
+
-
and a
) on the panel on the handle bars
+
button is pressed, the LEDs illuminate
16
Advertisement
Table of Contents
