Pedelec Mode And High Low Button; Throttle - Wisper 905se City Owner's Manual

Table of Contents

Advertisement

12
Pedelec mode and High Low box
12.1
When you first ride your Wisper bike you will notice that after one turn of the
pedals the motor will start working assisting you to ride the bike by adding
power through the rear wheel. This is the standard or pedelec mode, to
continue using the pedelec mode you must keep turning the pedals, if you stop
the motor will stop and the bike will slow to a halt. If you start pedaling again
after one turn of the pedals the motor will start again.
12.2
You will find a small black box on the handle bars with High and Low printed
below two green LEDs (small lights). When the Low button is pressed and the
LED above illuminates the assistance power in pedelec mode is 40% of the
maximum power available from the motor. When the High button is pressed
and the LED above illuminates the assistance power in pedelec mode is 80% of
the maximum.
12.3
High mode is generally used when you need the maximum amount of assistance
from the motor. Low mode is used when you do not need the instant assistance
power of 80%. Low mode is used in high traffic situations or poor conditions
such as ice and snow when 80% of full power could be dangerous.
13

Throttle

13.1
The throttle can be used in some countries such as the UK, Australia, New
Zealand USA, and Canada independently to the pedelec mode. Check with your
supplier if it is legal in your region. Bikes are usually set up to be legal in the
region in which they are supplied.
13.2
The independent use of the throttle, when available, will enable you to use the
throttle without pedaling.
13.3
The use of the throttle in pedelec mode is legal in most countries. Use of the
throttle in pedelec mode enables you to turn up the power to the motor as long
as you are pedaling the bike, if you stop pedaling the motor will stop too. If you
have the pedelec mode set to Low, you can increase the assistance from the
motor from 40% to 100% of available power simply but turning the throttle
towards you. This also works in High mode and will let you increase the power
from 80% to 100% of available power.
IMPORTANT Make sure your throttle grip and the grip on the left hand side of your
handle bars are always intact, in good condition and on the bike. Uncovered handlebar
tubes can be very dangerous in case of a collision.
- 11 -

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents