The On/Off Button; The Light Button; Pedelec Mode And Assist Button - Wisper 705se Owner's Manual

Hide thumbs Also See for 705se:

Table of Contents

On the handle bars

The ON/OFF button

10.1

To turn the power on so the pedelec and throttle work simply press the ON/OFF

button once, the lights will illuminate showing the power is on. When the ON/OFF

button is pushed again and the capacity indicator lights go out you have turned the

bike "off". When the bike is "off" you will not get any assistance from the battery

and motor and the bike is effectively simply an unpowered push bike.

11.1

The LIGHT button can be found close to the ON/OFF button. If you press it when

the bike power is on, the LED headlight on the front fork will illuminate. Press it

again to switch off the light. The power for the light comes from the bike battery.

Due to the low power consumption, use of the light will not reduce your range. On

2011 bikes, the switch will also activate the rear light.

12.1

When you first ride your Wisper bike you will notice that after one turn of the

pedals the motor will start working to assist you by adding power to the back wheel.

This is the standard or pedelec mode. To continue using the pedelec mode you

must keep turning the pedals, if you stop the motor will stop and the bike will slow

to a halt. If you start pedaling again after one turn the motor will start again.

12.2

You will find the ASSIST button on the panel on the handle bars with L.M.H (low,

Medium, High) with three LED's (small lights) on 2010 bikes. For the 2011 bikes,

there are six levels of pedal assist and a zero level where the motor does not

engage. When the button is pressed sequentially the LED shifts between the

various pedal assist levels.

12.3

High mode is used when you need the maximum amount of assistance from the

motor. Lower modes are used in high traffic situations or poor conditions such as

ice and snow when higher power could be dangerous.

- 13 -

Table of Contents