Table of Contents
Advertisement
2 Part 1 - Caring for your Wisper bike and pre use checks
Your Wisper bike has been thoroughly tested at the factory prior to delivery, and undergone a pre
delivery inspection as detailed in the table in appendix 1 of this manual. Please ensure the table has
been completed by your Wisper dealer.
It is very important that you check the bike thoroughly before its first use. Equally important are
frequent and regular spot checks, they will protect you and your Wisper bike. The bike must be
returned to the supplying dealer after approximately 300 miles/500km have been completed for a
second safety inspection as detailed in appendix 1.
Please read this manual carefully. Only on full understanding of all the functions of this electric
bicycle should you attempt to use it.
2.1 Before you set off for the first time
2.1.1
Check the handle bars and handle bar stem are properly tightened
2.1.2
Check all other nuts and bolts and fixings are properly tightened, pay particular attention to
the motor fixings, side kick stand, yoke and steering head bearings
2.1.3
Check brakes and brake isolators are functioning properly
2.1.4
Check tyre pressures are correct and tyres are not damaged
2.1.5
Check reflectors and lights if fitted are functioning properly
2.1.6
Make sure battery is fully charged
2.1.7
Load the battery into your bicycle's rear carrier and turn on the power ON/OFF button on
the battery. Lock the battery into the rear carrier to ensure the battery's output connection
is always connected properly. Remove the key.
4
Advertisement
Table of Contents
