Advertisement
PERLICK RESIDENTIAL INSTALLATION MANUAL FOR BEER DISPENSING EQUIPMENT
NOTE: Wash tapping devices thoroughly. Flush beer and
faucet lines, as well as the tapping device (keg coupler) with
fresh water.
1. Locate the dispensing head , black beer line(s), and
hose clamp(s). Slide one end of each beer line onto
the stainless steel tubes which protrude out the
bottom of the dispensing head and clamp tight.
2. Insert the beer line(s) through the hole in the counter
top. Position the head in place and apply silicone
around the base of the dispensing head. Fasten using
the 4 chrome screws included with the dispensing
head. Wipe off excess silicone to complete the seal.
3. Using the 3/8" -thick foam pad included in the
tapping kit and roll into a cylinder. From inside the
cabinet, insert the foam tube up through the hole in
the counter top until it is firmly against the insulation
in the dispensing head. Cut away any excess foam
that extends into the cabinet that extends into the
refrigerator.
4
perlick.com
Advertisement
