Installation
(continued) –––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
9. Secure unit to wall or cove molding with supplied bracket (Fig. 7) to
prevent tipping.
Note: Fasteners must be supplied by installer.
WARNING!
Freestanding unit must be secured to wall to prevent tipping.
Failure to do could result in personal injury or damage to the
unit.
Optional Leg Accessory Installation
1. If installing optional 6" (15.24 cm) Leg Accessory (item# 00956318),
tilt or lay base stand on side and screw each leg into stand (Fig. 8).
Optional Internal Water Filter Installation
If your dispenser has the internal water fi lter option, the water fi lter must be
installed for the dispenser to operate. Because internal components will need
to be accessed for both procedures, Follett recommends installing the water
fi lter just prior to initial sanitizing.
1. If installing the optional internal water fi lter, please complete the
steps shown in
Accessing Internal Components on page 11
before proceeding.
2. Lift and remove the top panel, set aside (Fig. 9.1).
3. Remove two screws (Fig. 9.2) and remove left side panel.
4. Install fi lter as shown. Turn fi lter clockwise until it is fully seated
(Fig. 9.3).
10
Dispenser and Ice machine 7CI100A/7FS100A
Fig. 7
Fig. 8
Fig. 9
1
2
3