Operation⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯⋯5 - Toyotomi Laser Clean LC-41 Instruction Manual

CAUTION : Always make sure that there is sufficient ventilation.
SET CLOCK
It is only possible to set the correct time, when the heater is
connected to the mains and not burning.
1. Use the Adjustment Keys ( ▼ hour / ▲ min.) to set the time.
2. To set the time, press "hour" and "min."
set buttons. Individual motions will
increase the time by one unit; holding
continuously will raise either the "hour" or
"min." rapidly. After approximately 10
seconds the blinking will stop and the
setting will be locked. 5 Minutes after
switching off the heater, the information on the display will disappear and the heater
will automatically switch into the stand-by position.
IGNITION
1. Just press the
heater. The
indicating that the ignition procedure has
started. This will take a short while.
2. After this time heater will automatically
ignite and The button will cease its flashing. The Operation Lamp will remain alight
so long as heater is burning.
NOTE : If using your heater for the first time, or after long term storage, ignition may
not take place on the first try. Press the
NOTE : Fuel pump may produce an audible operating noise at ignition. This is only
temporary.
OPERATION
button to ignite the
button will start blinking,
button again.
5
2
1