Operation - Toyotomi LC-33 Instruction Manual

CAUTION :Always make sure that there is sufficient ventilation.
SET CLOCK
It is only possible to set the correct time, when the heater is
connected to the mains and not burning.
1. Use the Adjustment Keys (▼ hour/ ▲ min.) to set the time.
2. To set the time, press "hour" and "min." set
buttons.
Individual motions will increase the time by
one unit; holding continuously will raise
either the "hour" or "min." rapidly. After
approximately 10 seconds the blinking will
stop and the setting will be locked. 5 Minutes
after switching off the heater, the information
on the display will disappear and the heater will automatically switch into the
stand-by position.
IGNITION
1. Just press the
ignite the heater. Operation
Lamp will start blinking,
indicating that the ignition
procedure has started. This
will take a short while.
2. After this time heater will automatically ignite and Operation Lamp will cease
its flashing. The Operation Lamp will remain alight so long as heater is burning.
NOTE: If using your heater for the first time, or after long term storage, ignition may
not take place on the first try. Press the power switch again.
NOTE: Fuel pump may produce an audible operating noise at ignition. This is only
temporary.

OPERATION

button to
5