Toyotomi Laser Clean LC-41 Instruction Manual page 8

TEMPERATURE REGULATION
1. Use the Adjustment keys ( ▼ hour / ▲ min.) to adjust the
temperature.
2. Adjust the temperature using the key on the right ( ▲ min.) to
set the temperature to a higher setting and the key on the left
( ▼ hour ) to lower the temperature.
3. Until the room temperature has reached the set temperature, the heater will burn at
either high or medium burning mode. When the room temperature reaches or
slightly exceeds the set temperature, the heater will automatically shift to maintain
the desired temperature.
NOTE : The standard setting of the heater is 20°C. However, once the set temperature
has been changed the new setting will remain in effect unless changed.
NOTE : Room temperature measurements are taken directly behind the heater.
These measurements may not represent the true room temperature.
SAVE OPERATION
The "SAVE" function allows you to limit the temperature. When
this function is activated, the heater will automatically switch off,
when the room temperature exceeds the set temperarure by
3 °C. Subsequently, when the room temperature has dropped
again to the set temperature, the heater will automatically
switch on again. Activate the "SAVE" setting by pressing the
Save key. The Save indicalor will light up. Switch off the
function by pressing the Save key once again.
NOTE : Without the "SAVE" setting your heater will maintain the set temperature by
approximation as well, by adjusting its heating capacity. "SAVE" is an economy
setting, which you can use when, for instance, you are not present in the room
or to keep it frost-free.
2
1
7