Operation - Toyotomi Laser Clean LC-32F Instruction Manual

CAUTION : Always make sure that there is sufficient ventilation.
SET CLOCK
It is only possible to set the correct time, when the heater is
connected to the mains and not burning.
1. Use the Adjustment Keys ( ▼ hour / ▲ min.) to set the time.
2. To set the time, press "hour" and "min." set
buttons. Individual motions will increase the
time by one unit; holding continuously will
raise either the "hour" or "min." rapidly. After
approximately 10 seconds the blinking will
stop and the setting will be locked. 5 Minutes
after switching off the heater, the information
on the display will disappear and the heater will automatically switch into the stand-by
position.
IGNITION
1. Just press the
that the ignition procedure has started. This will take a short while.
2. After this time heater will automatically ignite and The button will cease its flashing. The
Operation Lamp will remain alight so long as heater is burning.
NOTE : If using your heater for the first time, or after long term storage, ignition may not
take place on the first try. Press the
NOTE : Fuel pump may produce an audible operating noise at ignition. This is only
temporary.

OPERATION

button to ignite the heater. The
1
button will start blinking, indicating
button again.
5
2