Advertisement
ASSEMBLY AND OPERATION
INSPECTION AND ASSEMBLY
NOTE: Please save the shipping carton and packing materials for future storage of your heater.
1. REMOVE PACKING MATERIALS
Open the grille by raising the lower right hand corner of grille and pulling straight out. Slide the cardboard
packing down by spreading out to release the heat chamber assembly. Lift the heat chamber, in its protective
packing, out of the cabinet.
2. REPLACE THE HEAT CHAMBER
Remove the cardboard packing, and replace the heat chamber assembly. Point the wire handle to the front of the
heater.
Close the grille.
3. INSTALL THE BATTERIES
Locate the battery holder on the back of your heater.
Insert the battery 4 "C" size batteries according to the plus (+) and minus (–)
●
markings.
4. CHECK THE HEAT CHAMBER
If the chamber is raised, put it down and inlay it.
NOTE: If the heat chamber is raised, it can cause smoke and soot.
FUELING
WARNING: Use only clean kerosene (paraffin).
NEVER use gasoline (petrol) or other flammable liquids.
4
Advertisement
