Section 3: Operation; Introduction; Operating Specifications - Toyotomi NS-2800 Service Manual

3-1.

Introduction

The NS-2800 is an easy-to-operate vented heater. Routine operation features automatic
adjustment of room temperature, low fuel and power consumption. This section provides
all information necessary to operate the Laser Heating System. All operation procedures
specified should be performed in the order in which they are described.
3-2.

Operating Specifications

The following specifications apply to the operation of the NS-2800.
Model:
Type:
Ignition Type:
Fuel Type:
Heat Rating:
Fuel Consumption:
Heating Efficiency:
Power Source:
Power Consumption: Ignition: 96 W (3 minutes)
Normal Operating Current:
Current Fuse:
Safety Devices:
Flue Pipe (Pipe-in-pipe structure):
Air Duct:
Ventilation Capacity:

Section 3: Operation

NS-2800
Forced Flue (FF) type
Electric Lighting (Coil Heater)
Kerosene or Diesel Oil
(No.1 Fuel Oil in the U.S. and Canada)
High: 2,300 kcal/h (2,675 w/h, 9,800 BTU/h)
Low: 1,150 kcal/h (1,335 w/h, 4,900 BTU/H)
High: 0.28 L/h (0.07 gal/h)
Low: 0.14 L/h (0.04 gal/h)
Approx. 90%
DC 12V
Burning: High: 27 W, Low: 17W
High: 2.3 A, Low: 1.4 A
10 Amp.
Ignition safety device
Flame sensor
Overheat protector switch (High limit switch)
Power failure safety device
Burner temperature sensor
Low/High/Reverse power voltage safety device
Inner nominal: 25 mm (1 in.) diameter
Outer nominal: 50 mm (2 in.) diameter
65 mm (2-3/16 in.) or 75 mm (3 in.) diameter
Approx. 78 cubic meter/h (2,700 CFT/h)
(High mode without extension pipe)
14