Hardware Description - OPENTEL ODT 1500C User Manual

4) CONNECTING EXTERNAL AUDIO HI-FI SYSTEM
To connect any external Audio Hi-Fi system, the receiver is provided with two
RCA connectors at the rear, marked "Audio L and R" respectively to
connect the left and right audio.
In case of Audio Hi-Fi systems with digital audio input, please connect to
S/PDIF.
5) CONNECTING YOUR ANALOG RECEIVER
To facilitate users using analog receivers to view analog channels, the receiver
has been provided with a loop through terminal marked as "LOOP OUT".
Connect the coaxial cable from this terminal to the RF input terminal of your
analog receiver.
By keeping the receiver in standby, you will be able to tune and view analog
channels from your analog receiver.
6 HOW TO CONNECT YOUR RECEIVER

4. HARDWARE DESCRIPTION

4. A. FRONT PANEL
1) STANDBY BUTTON
Switches between operation and standby modes.
2) CH BUTTON
Moves the TV/radio channel up or down.
3) VOL BUTTON(Option)
Increases or decreases TV/Radio Volume
4) INFRARED SENSOR
Receives the IR commands from the RCU. Do
not block the view of the sensor.
5) 7 SEGMENT DISPLAY
Displays the current channel number. While the
receiver is in standby mode, the display will show
the current time.
6) SMART CARD SLOT
A slot for a Smart Card.
Although some TV and radio channels are free to
air, most TV and radio/music channels are
available on a subscription basis and can only be
enjoyed via a Conditional Access component.
The Conditional Access component is a
removable Smart Card.
Please note that the gold chip on the Smart Card
should face downwards and inwards when you
insert it into the Smart Card Interface.
7
HARDWARE DESCRIPTION