Firmware Upgrade Through Terrestrial - OPENTEL ODT 1500C User Manual

Hide thumbs

Table Of Contents

Table of Contents

Channel Search Results

A channel search may take several minutes before it is completed. All new found

channels are listed on the screen and automatically added to the "All channels"

channel list.

You can stop the search at any time by selecting the "Stop the channel search"

menu item.

If the search is finished, you can start it again by selecting "Restart the channel

search".

5.D. Smart Card

Entering smart card settings will bring up a new menu where you can control your

smart card and its settings, for example see information about your subscription, age

levels and change the smart card PIN code.

5.E. Sys

5.E. System Maintenance

5.E. Sys

tem Maintenance

• The options under the "System Maintenance" menu are used to upgrade your

receiver to a new software version (if broadcasted) or to re-install your system from

scratch.

• To upgrade the receiver software, select "Software Update" from the menu. New

software may include new or improved features for the receiver.

Note: It may take several minutes to upgrade the receiver - Never turn the

receiever off while upgrading. Also avoid to disconnect the antenna cable, or using

the remote control. Failure to upgrade the software may result in a damaged receiver

that must be sent for a service.

• To re-install the receiver, and start the complete installation procedure from

scratch, select "Reinstall" from the menu. If you do a reinstallation, all your previous

settings, including favourite channel lists, will be erased and set to factory default.

MENU OPERATION

6. User's Manual

• The built-in user instructions can be read by selecting "User's Manual" in

the main menu.

• To exit, press

• Select chapter with

and

• Browse between the pages within the current chapter with

FIRMWARE UPGRADE THROUGH

TERRESTRIAL

Upon installing the new receiver, please make sure it detects the new

firmware with the following procedures.

1. Turn on the receiver.

2.Select [Main Menu

System Configuration

Software Update]

3. As soon as the "

" button is pressed, the receiver will detect the new

firmware.

For the more detailed expalanation, please refrer to the 5.E System Maintance

in Menu opration