Hardware Description - OPENTEL ODT 4000V User Manual

4. HARDWARE DESCRIPTION

4. A. FRONT PANEL
1) POWER : This key is used to turn the receiver on and off
(stand by).
POWER
2) CH : These keys are used to change the channels.
CH
3) VOL : These keys are used to increase and decrease the
volume level manually.
VOL
4) INFRARED SENSOR : This is to receive the IR commands
from the RCU. Do not block the view of the sensor.
INFRARED SENSOR
5) 7 SEGMENT DISPLAY : This SEGMENT display will show
the current channel number.While the receiver is in stand by
mode, the display will show the current time.
7 SEGMENT DISPLAY
6) LED DISPLAY: This LED display will show the current
power mode status.
If receiver is in stand by mode,stand by mode LED will be on.
and when receiver is in on mode, on mode LED will be on.
LED DISPLAY
(Option for LED display model only)
7) CI CAMSLOTS : 2 Slots for Common Interface CAM
(VIACCESS, IRDETO, NAGRAVISION, CRYPTOWORKS,
CONAX, SECA) with smart card.(Option for CI model only)
CI CAM SLOTS
8) SMART CARD INTERFACE SLOTS : To watch scrambled
channels you should insert a smart card into Smart Card
Interface issued the service provider whom you subscribes to.
SMART CARD
Therefore you can watch only a specific range of channels with
INTERFACE SLOTS
entitlements in smart card. The smart card includes information
to decipher parameters necessary for descrambling the
program. Please note that the gold chip on the smart card
should face down and inward when you insert it into Smart
Card Interface. (Option for CAS model only)
6 HARDWARE DESCRIPTION
4. B. REAR PANEL
1) ANTENNA : This port is to connect the coaxial cable. The IF input is provided through
this port and the input frequency range is 174~862 MHz.
In order to get the signal from other receiver instead of the antenna, set "Tuner 5V"
option to "Off". You can find "Tuner 5V" option in "Automatic Channel Search".
2) LOOP OUT : To enable the connection of an analog receiver, The receiver is
provided with this port. Connect this port to ANTENNA port of the other receiver via RF
Cable.
3) SERIAL PORT : This is used to connect your receiver with computer through a serial
cable. This port can be used for upgrading software.
4) TV SCART : This is used to connect your TV through SCART.
5) VCR SCART : This is used to connect your VCR.
(When you connect external sets to above two SCART sockets, always use fully
featured SCART cables)
6) S/PDIF DIGITAL OUTPUT : This port is for the connection to the external Hi-Fi
system which has a optical S/PDIF input interface. (Option)
7) VIDEO, AUDIO R/L : These RCA connectors are used to connect any external video
and audio.
8) ANT IN : This is used to connect your local RF channels to your TV through
Loop.(Option)
9) TV OUT : This is used to connect your TV through RF cable.(Option)
10) POWER INPUT : This is to plug in the AC mains power cord.
The input AC volts range is 100V to 240V, 50Hz/60Hz supply.
7
HARDWARE DESCRIPTION