Table of Contents
Advertisement
3. Parental Control
• Box lock active: Using this option the whole receiver may be blocked: To unlock
the receiver the PIN code must be entered. The receiver stays in an unlocked state
until it goes back to standby mode or is turned off.
• Channel lock active: If the channel lock feature is active, individual channels
may be marked as locked. To temporary unlock a locked channel, the
can be pressed and the PIN code entered. Note: The channel stays in its unlocked
state until a channel change is done.
• Lock Channels: In the "Lock Channels" view, you can control which channels
should be locked by a PIN code.
• Age rating control: Toggle the age rating control on or off with
If you activate the age control, also specify a suitable age level under "Age Limit:".
• Age Limit: If a TV-program is shown on the selected TV-channel that has an
age limit above the setting, a PIN code will be required to watch it.
Be aware that not all Service Providers send the necessary codes for this
function to work. To increase or decrease the age setting, use
• Change PIN code: Use this function to change your PIN code to some
other four digit number.
•
New PIN: Enter a new four digit PIN code by using the (0) to (9)
buttons on the remote control.
•
Verify new PIN code: Re-enter the same new four digit PIN code
once again to verify that you got it right.
22
MENU OPERATION
To open the "Parental Control" menu
you will be asked to enter your access
PIN code. All parental control features
work on a locking concept with the
PIN code as your entrance key.
The PIN code is set to 0000 at the
factory!
button
and
.
and
.
4. Timer
Timers are used to program the receiver to wake up at a certain time and tune to a
specified channel.
Timers are normally used to record a TV programme on the video recorder, or to
pre-program the receiver for other reasons (wake-up, etc). A set timer causes the
receiver to wake up from standby mode at the specified time and change the
channel to the specified one. Please note that the VCR must be programmed
separately.
If you use a timer to record a TV show to i.e. a video recorder (VCR), also remember
to program your video recorder in parallel at the same time as you have set the
timer in the receiver.
Note: If you use the SCART connector from the receiver to your VCR, most VCR's
should be set to record from 0 channel.
5. System Configuration
System Configuration menues are used to control the more advanced features of
the receiver, such as doing regional settings, channel searches and other system
settings.
23
MENU OPERATION
Advertisement
Table of Contents
