Combustion Blower Replacement; Glass Replacement - Quadra-Fire MTVERNON-AE-MBK Owner's Manual & Installation

Mt. Vernon Pellet Stove (AE)
F. Combustion (Exhaust) Blower
Replacement
1. Follow the proper shut down procedures as outlined on
page 25, Section 10A.
2. Remove the right side panel by removing the 4 screws
using a Phillips head screw driver. Figure 30.1.
3. It is not necessary or recommended to remove the
housing to replace or service the combustion blower.
You only need to remove the motor and impeller.
4. Disconnect the wire from the control board connection
points #1 and #8. Depress the tab on the connector to
disconnect the wire (similar to a telephone connector).
See Figure 31.1 on page 31 for the locations of #1
and #8.
5. Using an 11/32 socket or nut driver, remove the (6)
8x32 nuts securing the motor and impeller to the hous-
ing.
6. Holding the black plastic body of the motor, rotate the
impeller counter-clockwise until blades line up with
opening in the housing and remove motor and impel-
ler.
7. If the gasket between housing and motor is damaged it
will have to be replaced. A gasket is included with the
replacement blower.
8. Re-install in reverse order.
Remove
Side
Panel
Figure 30.1
Page 30
Remove (6) Nuts
G. Glass Replacement
• Glass is 5mm thick high temperature heat-re-
sistant ceramic glass.
• DO NOT REPLACE with any other material.
• Alternate material may shatter and cause
injury
a. Swing open the face and remove the door from the
appliance by lifting the door off of the hinge pins and
lay on a fl at surface face down.
b. Using a Phillips head screw driver, remove 4 screws,
2 on the top and 2 on the bottom. Remove metal
bracket and then remove the glass. Figure 30.2c.
Replace with new glass with gasket.
d. Re-attach metal bracket with 4 screws.
e. Re-install door over hinge pins and close face.
Remove 4 screws
Figure 30.2
7034-106B
WARNING
Metal Bracket
Glass with Gasket
December 22, 2006
R