Seatback Positioning; Adjusting The Leg Support - Joovy Groove 0080X Series Instruction Manual

Seat back Positioning
The seat back can be adjusted to any position from fully
upright to reclining. The fully upright position should only be
used for a child that is at least 6 months old.
• Engage the rear wheel brakes.
• Locate the recline mechanism near the backside of the
seat.
• To recline the seat, grasp the recline mechanism, press
the top release button, and gently pull toward the rear of
the stroller until the seat is in the desired position. See
Figure 14.
• To adjust the seat back to a more upright position, pull
the strap at the end of the recline mechanism upward
while pushing the mechanism forward until the seat back
is in the desired position. See Figure 15.
NOTE: To get the seat back in it most upright position you
may need to push the seat back toward the front of the
stroller before pulling the straps.
ALWAYS ensure that the seat back is secured into position before
placing a child in the seat. Push down on the seat back to be sure it
is secure. NEVER adjust the seat back when the child is in the seat.

Adjusting the Leg Support

The leg support can be adjusted to two positions-horizontal
or all the way down.
• Engage the rear wheel brakes.
• To place the leg support into the horizontal position, pull
up on both sides of the leg support until it is locked into
position. See Figure 16.
• Push down on both sides of the leg support to ensure it is
secure.
• To place the leg support into the down position, locate
the trigger mechanism underneath BOTH sides of the leg
support on the bottom. Pull BOTH triggers and rotate the
leg support down. See Figure 17.
NOTE: The leg support does not "lock" into the down
position, but will remain there by gravity only.
WARNING
!
NEVER allow a child to step onto or sit
on the leg support. This may cause the
stroller to tip over and injure the child.
Groove Instruction Manual
WARNING
!
Figure 14
Figure 15
Figure 16
Figure 17
Page 6