Newland NLS-HR3250-SX User Manual page 35

To enable/disable the Timeout Between Decodes (Same Barcode), scan the appropriate barcode below.

Enable Timeout Between Decodes: Do not allow the scanner to re-read the same barcode before the Timeout
Between Decodes (Same Barcode) occurs.

Disable Timeout Between Decodes: Allow the scanner to re-read the same barcode.
**【Disable Timeout Between Decodes】
Set the Decode Session Timeout to 1500ms:
1.
2.
3.
4.
5.
35
Scan the Enter Setup barcode.
Scan the Decode Session Timeout barcode.
Scan the numeric barcodes ―1‖, ―5‖, ―0‖ and ―0‖. (See the ―Digit Barcodes‖ section in Appendix)
Scan the Save barcode. (See the ―Save/Cancel Barcodes‖ section in Appendix)
Scan the Exit Setup barcode.
【Enable Timeout Between Decodes】
【Enter Setup】
**【Exit Setup】