Training Computer; Transmitters - Polar Electro Cardio GX User Manual

Transmitter/Exerciser
is not shown during
online training.

TRAINING COMPUTER

Below you can find help to some common problems with training computer usage with the Cardio GX system.
Problem Cause
The heart rate Your Polar training
is not dis- computer is not
played on the compatible with the
training com- Polar Team² trans-
puter display. mitters.
Your Polar training
computer is not in
training mode.

TRANSMITTERS

Below you can find help to some common problems with transmitters with the Cardio GX system.
Problem
The connector cannot
Connector's battery is
empty.
Strap's electrode
areas are dry or strap
is secured incorrectly.
Connection between
the PC and the base
station is not estab-
lished correctly.
Base station's battery
is empty.
There exerciser is not
signed up for the ses-
sion.
Connector is in non-
secured mode.
Solution
For example, the following Polar training computers are com-
patible with the Polar Team2 transmitters: FT1, FT2, FT4, FT7,
FT40, FT60, FT80, RS100, RS300X, RS400 and RCX5. Full list
of compatible training computers can be found at
Set your training computer in training mode. Usually, it is done by
pressing the Red or OK button twice. For more information, see
the user manual of your Polar product.
Cause Solution
The con- Change the connector's mode to non-secured by removing the
Recharge connector's battery.
Wet the electrode areas of the strap under running
water. Make sure that the strap is secured correctly
and the wet electrode areas are firmly against exer-
ciser's skin.
Make sure the connection between the base station
and the PC is established correctly.
Plug the power cable into the base station and into
wall outlet.
The exerciser should sign up for the session.
Change the connector's mode to secured by removing
the connector from charger and inserting it back after a
minimum of 3 seconds. Only one sound should be
heard.
44
Polar website.