Table of Contents
Advertisement
WEARING THE TRANSMITTER
In order for the transmitters to work properly (detect
and transmit heart rate data), follow the instructions
below.
1. Wet the electrode areas of the strap well under
running water.
2. Attach the connector to the strap. Adjust the
strap length to fit tightly but comfortably.
3. Tie the strap around your chest, just below the
chest muscles, and attach the hook to the other
end of the strap.
Note that if you are wearing a sports bra,
l
place the strap below the bra.
4. Check that the wet electrode areas are firmly
against your skin and that the Polar logo of the
connector is in a central and upright position.
When the transmitter starts detecting
l
and transmitting your heart rate, you can
hear a short beep and a green light starts
blinking on the connector. Now you can
also monitor your heart rate with a
patible Polar training
After training, detach the connector from the strap
and follow the
care and maintenance
A Team² connector can be used only with a Team² strap.
USING ONE COMPUTER IN CARDIO GX SYSTEM
SYSTEM REQUIREMENTS
Get to know with the system requirements in
LOCAL AREA NETWORK
To connect your PC to the base station and to the internet, a local area network has to set up. Usually a local
area network is set up by using a router.
The router is connected to the internet.
l
The computer is connected to the router. The computer has access to the internet through the router.
l
The main base station is connected to the router with the network cable provided in the set.
l
com-
computer.
instructions.
System
requirements.
18
Advertisement
Table of Contents
