System Settings; Base Stations; Connectors; Setting Up Base Stations - Polar Electro Cardio GX User Manual

SYSTEM SETTINGS

The system setup is always done with the reception tool. Access system settings in the reception tool by
selecting System Settings. Use the system settings to manage the base stations and connectors.
The hardware must be taken into use before arranging heart rate-based training sessions. An easy-to-under-
stand wizard guides you through the setup process. Setting up the hardware must be done only once. See
more in

Setting up base stations

The Cardio GX system consists of 1-3 base stations and 1-2 computers. Reception tool and session tool
can be installed onto same or separate computers depending on your Cardio GX system setup.

BASE STATIONS

After the set-up wizard is completed, the base stations are displayed and managed on the left side of the sys-
tem settings. The connection status is shown for all base stations.

CONNECTORS

After setting up wizard, the connectors are displayed and managed on the right side of the system settings.
The Cardio GX reception tool informs about problems with connectors in the connector box.
The following information is displayed for the connectors:
Connectors in the system: added connectors are listed in the connectors box.
l
Battery status: the green bar displays the battery status of a connector when the connector is in
l
charger and the computer is connected to the main base station.
Errors: take the mouse cursor on the marked connector to read the error message.
l
SETTING UP BASE STATIONS
Set up the base stations with the system settings wizard which starts automatically when accessing System
settings for the first time. An easy-to-understand wizard guides you through the setup process. After setting
up the base station, teach the connectors
The Cardio GX system consists of 1-3 base stations and 1-2 computers. Reception tool and session tool can
be installed onto same or separate computers depending on your Cardio GX system setup. The system setup
is always done with the reception tool.
If there is more than one base station or more than one computer in the Cardio GX system, a router is needed
to connect the pieces together. A router is also needed if the system is connected to the internet. See also
System requirements.
and Teaching connectors.
to the system.
31