Ping; Software Upgrade; Figure 22. Ping Generation Screen; Figure 23. Software Upgrade Screen - Canoga Perkins 2370 User Manual

4.17 PING

Use the PING Generation screen to test the connection to a specific IP address. To use the PING
option, see Figure 20 and follow these steps:
----------PING Generation----------------------------------
IP Address to PING: 0.0.0.0
PING count (1 to 255, 0 = forever):
Use TAB key to move to other field,
and ENTER to validate.

Figure 22. PING Generation Screen

1. From the Main Menu, type 6, Utilities, and press <Enter>.
2. From the Utilities menu, type 8, PING Generation, and press <Enter>.
3. At the prompt, type the IP address to PING and press <Tab>.
4. At the prompt, type the number of times to send a PING, from 1 to 256, or type 0 to PING
continuously every 3 seconds, and press <Enter>.
"PING response received..." indicates a good connection;
"TIMEOUT: Unable to reach [IP address]..." indicates a faulty connection.
5. To stop the PING and return to the Utilities menu, press <Esc>.

4.18 Software Upgrade

Use the Software Upgrade screen to check the current version of the firmware and upgrade it and the
remote 2370, if necessary. See Figure 23. To access the Software Upgrade screen and check the
software version, follow these steps:
1. From the Main Menu, type
screen appears.
---------------------------SOFTWARE UPGRADE-------------------------------
Active Firmware
Inactive Firmware
Bootcode
1) Software Reset
2) Swap Bank
3) Copy Software from Source modem to Destination modem
4) Get New File with TFTP

Figure 23. Software Upgrade Screen

4-18
0
, Software Upgrade, and press <Enter>. The Software Upgrade
7
Local
Pri Offline Sec.
Last Data
01.00
01.01
05.00
Reset Reset
Swap Swap
Model 2370 Model User Manual
Remote
Pri Offline Sec.
Last Data Last Data
01.00
01.01
05.00
Reset Reset
Swap Swap