Table of Contents
Advertisement
4.10 SNMP Configuration
Use the SNMP Configuration screen to view and set up the SNMP parameters on the 2370. See
Figure 15 and Table 16. To view SNMP parameters, follow these steps:
1. From the System Configuration menu type 5, "SNMP Configuration," and press <Enter>. The
SNMP Configuration screen appears.
2. Type the number for the alarm you want to set and press <Enter>.
3. Type the information or value, and press <Enter>.
4. To return to the System Configuration menu, press <Esc>.
---------------------------SNMP CONFIGURATION-----------------------------
Ethernet Address
Ethernet Link
1)
System Contact
2)
System Name
3)
System Location
4)
Read Community
5)
Write Community
6)
SLIP/PPP IP Address
7)
Ethernet IP Address
8)
Subnet Mask
9)
Default Gateway
10) BOOTP Enabled
11) Serial Port Config
12) Telnet Timeout
13) Host Table
Figure 15. SNMP Configuration Screen
Table 16. SNMP Configuration Parameters Description
Item
1) System Contact
2) System Name
3) System Location
4) Read Community
5) Write Community
6) SLIP/PPP IP Address Enter the IP address for access through SLIP or PPP
7) Ethernet IP Address
8) Subnet Mask
9) Default Gateway
EdgeAccess® Universal Chassis System
00 40 2A 00 53 E7
UP/Half Duplex
public
public
0.0.0.0
172.16.143.10
255.255.0.0
172.16.1.1
No
VT100
Never
Who is responsible for the 2370, up to 50 characters
What you call the 2370, up to 50 characters
Where the 2370 is located, up to 50 characters
Name for the people who can view the reports, up to 10 characters;
default is public
Name for the people who can set values for parameters, up to 10
characters; default is public
Enter the IP address for access through the Ethernet network
Enter the mask that sets the network ID part of the IP address
Enter the address of the network node that connects to another
network
Model 2370 Model User Manual
Description
4-11
Hide quick links:
Advertisement
Table of Contents
