Trap Configuration; Figure 13. Trap Configuration Screen; Table 14. Trap Definitions - Canoga Perkins 2370 User Manual

4.8

Trap Configuration

Traps are messages that require management attention and are routed to the Network Manager, but do
not trigger alarms. Use the Trap Configuration screen to view the current configuration and to enable
or disable traps for the 2370. See Figure 13 and Table 14. To configure traps, follow these steps:
1. From the System Configuration menu type 3, "Trap Configuration," and press <Enter>.
2. At the Trap Configuration screen, type the number for a trap and press <Enter>.
Note: "Master Trap Control" enables or disables all traps; the default is Disabled.
2. Press <Space> to cycle to Enabled or Disabled and press <Enter>.
3. To return to the System Configuration menu, press <Esc>.
------------------------TRAP CONFIGURATION--------------------------------
1) Master Trap Control
2) LOS/CLS Traps
3) SQL Traps
4) Redundancy Traps
5) Configuration Traps
6) Diagnostic Traps
7) Authentication Traps
8) Power/Fan Malfunction Traps
9) Cold Start Traps
10) Alarm Input Traps
11) Security Violation Traps

Figure 13. Trap Configuration Screen

Table 14. Trap Definitions

Type of Trap
2) LOS/CLS
3) SQL
4) Redundancy
5) Configuration
6) Diagnostic
7) Authentication
8) Power/Fan Malfunction
9) Cold Start
10) Alarm Input
11) Security Violation
EdgeAccess® Universal Chassis System
Loss of Signal (electrical)/Composite Loss of Signal (optical); one
or both received signals fail
Squelch (for received signal)
Monitors redundant operation activity
Setup errors, including mismatches with other modems
Monitors loopback
Checks for SNMP access and read/write community string
Power is low or fan is off
Monitors the reset function
UCS 1001 function; see the UCS 1001 User Manual
Not used
Model 2370 Model User Manual
Disabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Definition
4-9