Table 7. Trap Configuration Options; Table 8. Alarm Configuration Options - Canoga Perkins 2345 User Manual

Table 7. Trap Configuration Options

Trap
Active Link/Modem
Inactive Link/Modem
Configuration
Diagnostic
Authentication
Power/Fan Malfunction The power supply or fan fails
Cold Start
Alarm Input
Use the Alarm Output Configuration screen to view the current configuration and to enable or disable
alarms for the 2345. For a list of events that trigger alarms, see Table 7. To set up the alarms, follow
these steps:
1. At the System Configuration menu, type 3, "Alarm Configuration," and press <Enter>.
2. At the Trap Configuration screen, type the number for a trap and press <Enter>. See Table 8.
3. Press <Space> to cycle to Enabled or Disabled and press <Enter>.
4. To return to the System Configuration menu, press <Esc>.
These selections do not affect how the CIM Major and Minor LEDs report alarms.

Table 8. Alarm Configuration Options

Alarm
Active Composite Link
Electrical Loss of Signal
Electrical Yellow/Blue/Red Loss of sync, remote fault, or AIS (can be All 1s or Alarm Indication
Configuration
Power Supply
Power-On Self Test
Inactive Composite Link
EdgeAccess Universal Chassis System
When enabled, sends a Trap if. . .
The active link fails; the remote device goes on- or offline; or redundancy
switches between primary and secondary
The inactive link fails or the redundant local or remote device goes on- or
offline
The 2345 is set up incorrectly
Loopback is enabled or disabled
An unauthorized host attempts SNMP access to the 2345
The 2345 is reset by a power failure or forced reset
The 2345 received an alarm (standalone only)
When enabled, sends an alarm if. . .
The fiber link fails (active signal in a redundant configuration)
The electrical input signal fails
Signal) occurs
The 2345 is set up incorrectly or the local and remote software versions do
not match
The power supply or fan fails
Self test fails at power-up
The inactive fiber link fails (redundant configuration, only)
Model 2345 User Manual
3-7