Esc Activation/Malfunction Indicator Light And Esc Off Indicator Light - Jeep Liberty 2011 Owner's Manual

to the PARK position and then moved out of the PARK
position. This will occur even if the message was
cleared previously.
WARNING!
With the ESC switched off, the enhanced vehicle
stability offered by ESC is unavailable. In an emer-
gency evasive maneuver, the ESC system will not
engage to assist in maintaining stability. "Full Off"
mode is only intended for off-highway or off-road
use.
ESC Activation/Malfunction Indicator Light and
ESC OFF Indicator Light
The "ESC Activation/Malfunction Indicator
Light" in the instrument cluster will come on
when the ignition switch is turned to the ON
position. It should go out with the engine
running. If the "ESC Activation/Malfunction Indicator
Light" comes on continuously with the engine running, a
malfunction has been detected in the ESC system. If this
light remains on after several ignition cycles, and the
vehicle has been driven several miles (kilometers) at
speeds greater than 30 mph (48 km/h), see your autho-
rized dealer as soon as possible to have the problem
diagnosed and corrected.
The "ESC Activation/Malfunction Indicator Light" (lo-
cated in the instrument cluster) starts to flash as soon as
the tires lose traction and the ESC system becomes active.
The "ESC Activation/Malfunction Indicator Light" also
flashes when TCS is active. If the "ESC Activation/
Malfunction Indicator Light" begins to flash during ac-
celeration, ease up on the accelerator and apply as little
throttle as possible. Be sure to adapt your speed and
driving to the prevailing road conditions.
STARTING AND OPERATING 353
5