Jeep Liberty 2011 Owner's Manual page 322

320 STARTING AND OPERATING
Use the transfer case NEUTRAL position for recreational
towing only. Refer to "Recreational Towing" in "Starting
and Operating" for further information.
CAUTION!
• Do not attempt to make a shift while only the front
wheels or rear wheels are spinning. The MP1522
Command-Trac transfer case is not equipped
with a synchronizer and therefore the speed of the
front driveshaft and rear driveshaft must be equal
for the shift to take place. Shifting while only the
front wheels or rear wheels are spinning can cause
damage to the transfer case.
• The 4WD LOCK position and 4WD LOW position
are intended for loose or slippery road surfaces
only. Driving in these positions on dry hard-
surfaced roads may cause increased tire wear and
damage to the driveline components.
• When operating your vehicle in 4WD LOW, the
engine speed is approximately three times that of
the 2WD position or 4WD LOCK position at a
given road speed. Take care not to over-speed the
engine and do not exceed 25 mph (40 km/h).
• Proper operation of four-wheel drive vehicles de-
pends on tires of equal size, type, and circumfer-
ence on each wheel. Any difference in tire size can
(Continued)
cause damage to the transfer case. Tire rotation
schedule should be followed to balance tire wear.
CAUTION! (Continued)