Front/Rear Axle Fluid - Jeep Liberty 2011 Owner's Manual

Adding Fluid
Fluid should be added only to fill hole until fluid begins
to run out of the hole.
Draining Fluid
First remove the fill plug (1), then the drain plug (2).
Recommended tightening torque for the drain and fill
plugs is 15–25 ft lbs (20–34 N·m).
CAUTION!
Do not over-tighten the plugs. You could damage
them and cause a leak.
Lubricant Selection
Use only manufacturer's recommended fluid. Refer to
"Fluids, Lubricants, and Genuine Parts" in "Maintaining
Your Vehicle" for further information.
MAINTAINING YOUR VEHICLE 467
Frequency Of Fluid Change
Under normal operating conditions, the fluid installed at
the factory will give satisfactory lubrication for the life of
the vehicle. Fluid changes are not necessary unless the
fluid becomes contaminated with water. Change the fluid
immediately if contaminated with water.

Front/Rear Axle Fluid

For normal service, periodic fluid level checks are not
required. When the vehicle is serviced for other reasons
the exterior surfaces of the axle assembly should be
inspected. If gear oil leakage is suspected inspect the
fluid level. Refer to "Fluids, Lubricants, and Genuine
Parts" in "Maintaining Your Vehicle" for further informa-
tion.
Fluid Level Check
• Front axle lubricant should be at the bottom edge of
the oil fill hole when the vehicle is in a level position.
7