Time And/Or Date Is Not Correct; Error Messages On The Screen; Restoring The Hard Disk Contents; Tips - Fujitsu Siemens Computers SCENIC E Operating Manual

Professional pc
Table of Contents

Advertisement

Troubleshooting and tips

Time and/or date is not correct

You can set the time and date in the BIOS Setup or in the operating system.
Set the time and date.
If the time and date are repeatedly wrong when you switch on your PC, the on-board
i
battery is flat. Change the lithium battery as described in the "Extensions to the
mainboard" - "Replacing lithium battery" chapter.

Error messages on the screen

Error messages and their explanation are contained:
in the technical manual for the mainboard
in the "BIOS Setup" manual
in the documentation for the programmes used

Restoring the hard disk contents

Should you need to restore your hard disk, the instructions are provided on the case of the
"Recovery CD" (delivered with your system).

Tips

The PC cannot be switched off with the ON/OFF switch
Cause: The PC was not switched on with the ON/OFF switch.
Press the ON/OFF switch again.
Cause: System crash
Press and hold the ON/OFF switch for at least four seconds until the PC switches off. The
operating system is not shut-down properly in the process. Error messages are therefore
possible the next time the system is booted.
Out of system resources
If you have too many applications running at once, you may experience problems due to a lack of
system resources. In this case you should:
close unnecessary applications
or
run the applications in a different order
Other manuals
Additional manuals are provided as PDF files on the "User Documentation" or "Drivers & Utilities"
CD.
30
A26361-K675-Z120-1-7619, edition 3

Advertisement

Table of Contents
loading

Table of Contents