Operation; Switching On The Pc; Switching Off The Pc - Fujitsu Siemens Computers SCENIC E Operating Manual

Operation

Switching on the PC

► If necessary, switch the monitor on (see the operating manual for the monitor).
► Switch the PC on with the main power switch on the rear of the PC.
► Press the ON/OFF switch on the front of the PC.
The power-on indicator lights green and the PC is started.

Switching off the PC

► Shut down the operating system properly. For Windows: select Shut Down from the Start menu.
► If the operating system does not automatically switch the PC off, turn the PC to ready-to-
operate when requested to do so by pressing the ON/OFF switch.
If the PC is ready-to-operate, the PC consumes very little power.
Switch off the PC at the power switch. The PC no longer uses any power.
The main power switch and the power button do not disconnect the PC from the mains
!
voltage. To completely disconnect the mains voltage, remove the power plug from the
socket.
► If necessary, switch the monitor off (see the operating manual for the monitor).
Placing a PC (with soft power off function) in a ready-to-operate state by means of software
With the soft power off function the PC automatically switches off (standby) or switches into the
energy-saving mode after the operating system is shut down. Requirements: Your system must
support switching off with software and this functionality must be enabled in BIOS Setup. The soft
power off software may also need to be installed on Windows NT systems.
You can also switch your PC into the standby mode via the DeskView software with the DeskOff
programme.
A26361-K675-Z120-1-7619, edition 3 19