Basic Operation; Turning Power On - Icom iF3002 Instruction Manual

■ Turning power ON

Prior to using the transceiver for the first time, the battery pack
must be fully charged for optimum life and operation. (p. 23)
Rotate [VOL] to turn power ON.
➥
D Battery type selection
The battery type must be selected according to the battery pack or
case when it is changed, but only the first time it is used.
Check the battery type before you begin the selection procedure.
One to three beep(s) sound in sequence, so you must repeat the
steps until the number of beeps matches your battery type.
For example, if your battery type is a Li-Ion battery pack, you must
repeat the procedure until 1 beep is heard.
q Set [ROTARY SELECTOR] to any
channel other than Channel 16.
w R otate [VOL] to t
er power OFF.
e W hile pushing and holding [PTT],
rotate [VOL] to turn the power ON.
• You should hold [PTT] until the beep
sounds. (It takes approx. 5 sec.)
• 1 beep sounds when the Li-Ion bat-
tery is selected.
• 2 beeps sound when the battery
case is selected.
• 3 beeps sound when the Ni-MH battery is selected.
r After the beep sounds, release [PTT].
t Repeat steps w to r until you select the attached battery type.
NOTE: This operation may not be available, depending on the
presetting. Ask your dealer for details.

BASIC OPERATION

urn the transceiv-
[ROTARY SELECTOR]
[PTT]
3
1
2
3
[VOL]
4
5
6
7
8
9
10
11
12
[VOL]
13
14
15
16
17
18
19
20
12