en
Fig. I
Removing the double whisk
S Pull the whisks off the support.
Attaching the double whisk
S Push the whisks onto the support until they
lock into position (click").
Troubleshooting
Fault
ON/OFF display flashes,
appliance is not functioning
= electronic monitoring
system has been actuated.
If other malfunctions occur, please consult our customer service.
6
Remove and clean the filter
Fig. J
Twice a year the filter under the appliance
must be cleaned either by knocking out the
dirt or by using a vacuum cleaner.
Replace the filter if damaged, blocked or sticky
(following contact with liquids). Available from
customer service.
Cause
Applianceoverloaded,
e.g. blender blades jammed.
Power supply was interrupted.
Remedial action
Switch off appliance,
pull out mains plug,
eliminate cause,
reinsert mains plug,
switch on appliance again.
Switch off the appliance and
switch on again.