Troubleshooting - Porter-Cable PCC640 Instruction Manual

20 volt max 1/4” lithium-ion cordless impact driver

Hide thumbs Also See for PCC640:

Instruction manual (14 pages)

Table Of Contents

Table of Contents

Available languages

LED WORk LIGHT

When impact driver is activated by pulling the trigger switch (1), the integrated

LED work light (9) will automatically illuminate the work area. NOTE: The work light is

for lighting the immediate work surface and is not intended to be used as a flashlight.

Bit Tip Storage

Two magnetic bit storage slots (5) are built into the area on the top of the tool.

Battery fuel Gauge - figure G

The tool is equipped with a battery fuel gauge (8).

This can be used to display the current level

of charge in the battery during use and during

charging. It does not indicate tool functionality

and is subject to variation based on product

components, temperature and end-user application.

Checking battery charge during use:

• Press the battery fuel gauge button (G1).

• The three LEDs (G2) will illuminate indicating the

percent of charge in the battery (figure G).

• If LED light does not lluminate, charge battery.

NOTE: This battery is designed to not operate

when a charge below 20% of its capacity is reached. After the battery charge is

depleted, the tool will not operate until after the battery has been recharged.

Belt Clip - figure H

A belt clip (10) is provided which can be switched

to either side of the tool based on user preference

for convenient access and storage during use.

• Place the front lip of the belt clip (H1) into the

indentation of the base (H2).

• Secure the belt clip with the supplied screw and

firmly tighten with a phillips screwdriver.

CAUTION

Ensure the forward/reverse control

button (2) is in the center lock position before

attaching tool to belt.

Problem

• Unit will not start.

• Battery pack will not charge. • Battery pack not inserted into charger. • Insert battery pack into