Engine Stop/Run Switch; Check Engine Oil Level - Victory V92TC Owner's Manual

Engine Stop/Run Switch

Be sure the engine stop/run switch stops the engine, or prevents the engine from starting when set to the Stop
position.
If you regularly use this switch to shut off the engine, you are already checking its operation each
Notice
time you use the motorcycle.

Check Engine Oil Level

A dipstick attached to the oil fill cap registers the engine oil
level.
1. With the transmission in neutral, start and run the
engine for several minutes.
2. Shut the engine off and wait for 3- -5 minutes.
3. Straddle the motorcycle on level ground and bring it to
a vertical position. Remove the oil fill cap and wipe the
dipstick clean. Reinstall the dipstick and turn the cap
clockwise until it seats.
4. Remove the dipstick again and note the oil level.
5. If necessary, add or remove oil to bring the level into
the area on the dipstick above the ADD mark and
below the FULL mark (see "Engine Oil
Specifications," page 139). Repeat steps 1- -2 each time
you adjust the oil level.
Pre- -Operation Check
1
1. Oil Fill Cap/Dipstick
1 2
1. ADD Mark 2. FULL Mark
47