Install Battery - Victory V92TC Owner's Manual

1. To clean oxidation from the battery posts and cable connectors, use a wire brush. Wash the posts and
cable connectors with a solution of 1 part baking soda to 16 parts water. Rinse with clean water and
wipe dry. Apply a thin film of dielectric grease to the posts and cable connectors.
2. Following the charger manufacturer's instructions, use a battery charger designed for use with 12 volt
batteries. The charger should have a maximum charging rate of 1.8 amps. Charge the battery for
approximately 10 hours at a rate of 1.8 amps. If you use a taper or trickle charger, it will take longer
to charge the battery.
3. After charging the battery, use a voltmeter to check the condition of the battery. Allow battery to sit
1- -2 hours before checking the charge. The charge should be a minimum of 12.5 volts. Repeat the
charging cycle if the charge is less than the minimum. Replace the battery if it fails to reach a 12.5
volt charge after 2 complete charging cycles.

Install Battery

1. Before installing the battery, make sure it is fully charged and clean.
2. Slide the battery into position in the battery tray.
3. Connect the positive ( + ) battery cables (covered with a red boot).
4. Connect the negative ( - - ) cables (exposed connectors).
Caution
• Connecting the negative cable first can produce an electric shock that could result in damage or injury.
• Connecting the battery cables to the wrong terminals can severely damage the electrical system.
5. Reinstall the battery hold- -down strap.
6. Reinstall the left side cover.
Maintenance
107