Meat Probe Socket - Fisher & Paykel OB30DDEPX1 Service Manual

Service Manual 547226: OB30
Door Hinge removal
1. Remove the heat reflective glass pane. (no. 1, refer previous)
2. Remove the door hinge retaining screw near the top of the stanchion.
3. Lift the door hinge and hinge stanchion enough to clear the edge of the door cap.
(no. 8)
Caution: The inner edges of the stainless steel door cap are sharp.
4. Separate the door hinge from the hinge stanchion. (no. 7)
Reassembly
Refit in reverse manner.
Note: If the upper hinge arm is not loaded, use an
adjustable spanner to lower the upper arm so that
the loading clip from the lower arm can be fitted.

7.23 Meat Probe Socket

Location: Left hand side of the oven cavity
1. Remove the oven from the joinery cavity. (refer
to Section 7.1)
2. Remove the switch service panel adjacent to
the meat probe socket.
3. Remove the retaining nut securing the socket to
the inside of the oven.
4. Remove the meat probe socket through the
inspection hole.
5. Remove the spade terminals from the meat
probe socket.
Reassembly
Refit in reverse manner.
71
December 2012
Figure 7.22c
Figure 7.23a
Figure 7.23b