Cooling Fan; Vent Fan - Fisher & Paykel OB30DDEPX1 Service Manual

Service Manual 547226: OB30

7.16 Cooling Fan

Location: Back and top panel areas
Removal
Follow the general servicing instructions for components in the back panel area.
(refer to Section 7.3)
For single ovens and upper cooling fan on double ovens.
1. Remove the top panel
2. Remove the wires from the cooling fan motor.
3. Remove the two screws on the left of the cooling fan and slide it out from the locating
slot.
4. Remove the four small retaining screws for the cooling fan side brackets and transfer
the brackets to the replacement cooling fan.
Note: Check the replacement cooling fan is specified as in section 2.8.
For lower cooling fan on double ovens.
1. Remove the back panel. (refer to Section 7.3)
2. Remove the wires from the cooling fan motor.
3. Remove the two screws on the right of the cooling fan and slide it out from the
locating slot.
4. Remove the four small retaining screws for the cooling fan side brackets and transfer
the brackets to the replacement cooling fan.
Note: Check the replacement cooling fan is specified as in section 2.8.
Reassembly
Refit in reverse manner.
Follow the reassembly procedure. (refer to Section 7.5)

7.17 Vent Fan

Location: In the back panel area
Removal
For single ovens and upper cavity in double ovens
1. Follow the general servicing instructions for components in
the back panel area. (refer to Section 7.3)
2. Remove the vent fan retaining screws.
3. Remove the longest section of vent ducting.
4. Remove the vent fan wires.
5. Lift the vent fan out of the vent ducting and rotate counter-
clockwise to clear surrounding parts.
6. Separate the vent fan from the vent tube.
For lower cavity in double ovens
1. Follow the general servicing instructions for components in the back panel area.
(refer to Section 7.3)
2. Remove the vent fan retaining screw.
3. Remove the lower section of vent ducting.
66
December 2012
Longest
Ducting
Section
Lower
Ducting
Section