Service Manual 547226: OB30
5.13 SYMPTOM: Fault Code F1 displayed in Tech Select only
(Refer to 4.0 Diagnostics)
CAUSE:
Maximum allowable temperature 185° F (85° C) around e lectronics was exceeded.
DIAGNOSIS:
Check for cooling fan faults or vent blockages. (refer to Section 5.19)
5.14 SYMPTOM: Fault Code F2 displayed
CAUSE:
Maximum allowable cavity temperature was exceeded during Self-Clean Cycle.
DIAGNOSIS:
Check for temperature sensor faults. (refer to Section 5.23)
Check for oven element faults. (refer to Section 5.22)
Replace the power module if no other component faults can be found. (refer to
Servicing Instructions Section 7.9)
5.15 SYMPTOM: Fault Code F3 displayed
CAUSE:
The oven temperature was sensed at over 600° F (315° C) during normal cooking
operation.
DIAGNOSIS:
Check for temperature sensor fault. (refer to Section 5.23)
Check for oven element faults. (refer to Section 5.22)
Replace the power module if no other component faults can be found. (refer to
Servicing Instructions Section 7.9)
5.16 SYMPTOM: Fault Code F4 displayed
CAUSE:
A fault occurred in the power module.
PROCEDURE:
Check all the connections to the power module and clock module.
If the fault code re-occurs, replace the power module. (refer to Servicing Instructions
Section 7.9)
37
December 2012