A. Place the strainer into the spinning brush.
B. Place the strainer + spinning brush into the bowl. Make
sure the red dot on the strainer and the red dot on the bowl
C. Push in the squeezing screw into the strainer.
D. Assemble the hopper onto the bowl.
1. Make sure the arrow on the hopper and the red dot on the
bowl is aligned.
2.Make sure the arrow on the hopper is pointing to close sign
on the base.
E. 1. Assemble the entire Top Set onto the base.
2. As shown below, assemble the bowl onto the base and
twist the bowl so that the hopper edge is pointing to "close"
F. Must connect power cord. Place containers under both
ejections. (Juice&pulp ejection)