Auriga
Invacare
®
1
Safety and assembly instructions
These safety instructions are intended to prevent accidents, and it is imperative that they are observed.
1.1
Before any inspection or repair work
•
Read and observe this Service Manual and the associated operating manual.
•
Observe the minimum qualifi cation requirements for carrying out the work.
Caution:
•
Please take into account the heavy weight of some components. This applies especially to
removal of drive units and batteries.
•
The Scooter must be switched off before removal of voltage-carrying components. To do this
remove the batteries.
•
When making measurements on voltage-carrying components, avoid short-circuiting the
contacts.
•
Danger of fi re!
•
Use tools that are in good condition.
1.2
During dismantling / reassembly
•
Mark all current settings for the Scooter (seat, armrests, backrest etc.), and the cable connecting plugs
associated, before any removals. This makes reassembly easier.
Caution:
•
Support the Scooter when raised with suitable equipment before beginning removal or
reassembly.
•
Never use "standard" nuts instead of self-locking nuts.
•
Always use correctly dimensioned washers or spacers.
Note:
•
All plugs are fi tted with mechanical safety devices which prevent release of the connecting
plugs during operation.
•
To release the connecting plugs the safety devices must be pressed in.
•
When reassembling ensure that these safety devices are correctly engaged.
•
Cable binders which have been cut off during disassembly should be replaced by new ones
during reassembly.
Page 7
Service Manual