Replacing The Keypad And The Control Panel; Assembling / Disassembling The Steering Column Shroud - Invacare Auriga Service Manual

Auriga
Invacare
®
Pos.
Qty
4,07 1
4,08 1
4,2
1
4,17
1
4,21
1
4,23 1
4,3 1
4,3 1
4,28
1
4,34
1
4,4
1
4,4 1
4,37 1
4,38 1
4,38
1
4,5
1
4,42
2
4,43 1
4,45 1

9.9 Replacing the keypad and the control panel

9.9.1 Assembling / disassembling the steering column shroud

Part-No. Part Description
1421625 SCREW, M5 X 8 L
1421626 ALUM. WIRE END CAP
1421627 THROTTLE ASS'Y., 3W/4W
1421628 POTENTIOMETER
1421629 CONNECTING WIRE, POT
1421630 CONNECTING WIRE, SPEED POT
1421631 UPPER DASH BOARD SET, CANDY APPLE RED, 3W/4W
1421632 UPPER DASH BOARD SET, BLUE, 3W/4W
1421633 TOUCH PANEL, KEYPAD, 3W/4W
1421634 MAIN LOOM, TILLER, 3W
1421635 LOWER DASH BOARD SET, CANDY APPLE RED, 3W/4W
1421636 LOWER DASH BOARD SET, BLUE, 3W/4W
1421637 CHARGER SOCKET WITH WIRE
1421638 BACK MIRROR, RH
1421639 BACK MIRROR, LH
1421640 HEAD LIGHT WITH WIRE ASS'Y.
1421641 BULB, 24V/5W, INDICATOR LIGHT
1421642 BULB, 24V/18W
1421643 CONNECTING WIRE, HEAD LIGHT
•
•
•
•
•
•
•
•
•
•
Remove the plastic caps from the screws on the left
and right sides on top of the control panel, remove the
screws, and disconnect the circuit board.
Remove the control panel.
Remove the cap from the knob and remove the knob.
Remove the control circuit board and disconnect and
remove the keypad.
Lift the 2-ply keypad on one corner with a fl at tool
and pull it off.
Remove any remnants of adhesive left over after
removing the foil.
Reassembly is done in reverse order.
Remove the screws that hold the basket.
Remove the screws from the steering column shroud.
Remove the control panel (see above).
Disconnect the key switch with its cable from the
control circuit board, and remove the shroud.
Reassembly is done in reverse order.
Page 34
Service Manual