Auriga
Invacare
®
9.3.4 Removing and re-fi tting the front shroud (3+4-wheelers)
9.3.5 Removing and re-fi tting the rear shroud
Note:
When removing the rear shroud, fi rst detach the velcro fasteners on the sides, then pull the shroud up and
off. When re-fi tting the shroud, fi rst position both of the openings for the seat post and the de-clutching lever.
Then fi t the two tabs on the front of the shroud into the corresponding slots, push the shroud down, and
fi rmly press the velcro fasteners together.
•
Remove the seat and the rear shroud (see chapter 9.3.5).
•
Tilt the steering column towards the rear.
•
Roll up the rubber sleeve.
•
Loosen and remove the clamping lever, and
disconnect the cable.
•
Remove the steering column by turning and pulling
it upwards.
•
Remove all four screws under the foot mat.
•
Carefully detach the front shroud from the velcro strips,
and remove by pulling upwards.
Reassembly is done in reverse order.
•
Pull the lever that releases the seat.
•
Rotate the seat a quarter of a revolution in either direction
and remove the seat.
•
Carefully release the rear shroud from the velcro
fasteners.
•
Disconnect the cables that go to the lighting system and
the on-board charger, and remove the rear shroud.
Reassembly is done in reverse order.
Page 23
Service Manual