Additional Safety Instructions For Pumps - Yardworks YW1100PP Instruction Manual

ADDITIONAL SAFETY INSTRUCTIONS FOR PUMPS

Caution: Not intended for cleaning and other maintenance of swimming pools.
WARNING! This product is intended for pumping water in a Home Domestic application. Do not use it
for corrosive, abrasive, explosive or dangerous liquids. Fluids other than water will damage the water pump
and/or create a fire hazard.
This appliance is not intended for use by person (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
• Ensure the water pump is disconnected from mains power when installing.
• Do not install or operate the water pump in an explosive environment or near flammable material.
• Do not operate the water pump without liquid.
• Do not run the water pump dry.
WARNING! The water pump together with associated pipework operate under pressure. Do not
disconnect water pump or pipework until internal pressure has been released. Failure to do this could
result in personal injury and damage to property.
• Avoid inserting hands into the inlets/outlets of the water pump while it is connected to mains power.
• Before using the water pump, always inspect it visually. Do not use the pump if it is cracked and/or damaged.
If the water pump is damaged, contact Yardworks customer service.
• The water pump has a built-in thermal protection overload switch. The water pump stops if an overload occurs.
The motor restarts automatically after it has cooled down. The pump must not be used when people are in
the water.
Never work or perform maintenance on the pump without first making sure it has been disconnected from the
mains power.
Pollution of the liquid could occur due to leakage of lubricants.
Important: Avoid inserting hands into the mouth of the pump if it is connected to the mains. The electrical
connection must always be made in a dry area. Make sure that electrical connections are protected from
inundations. Protect the plug and the power cable from heat, oil or sharp edges. If damaged, the power cable must
be replaced by a qualified electrician.
8