Operation - Yardworks YW1100PP Instruction Manual

Turning the Pump On and Off
Note: When the pump is fully primed and air is flushed out of the suction cycle, the
pump is ready to operate. The pump may take several minutes to fully prime air from
the suction line and inside the pump.
1. Plug in and turn on the mains power (Fig. 10).
2. You can select one of the four operating modes using the MODE button as shown.
Operation Function
1. Standby Mode
2. Automatic Mode
Automatic mode enables
the pump to turn on/off
to ensure maximum
pressure is maintained.

OPERATION

LCD Control Panel
a)
b)
c)
d)
As soon as the mains power is turned on the
pump will automatically go into standby mode.
Depress the 'MODE' button once. The following screen
will appear with 'PL' on bottom right corner of the screen.
This shows on the initial start up that the pump is
pressurizing at the inlet and outlet.
P- The pump is pressurizing at the outlet
L- The pump is pressurizing at the inlet
This shows the pump is only pressurizing at
the outlet.
This shows the pump is only pressurizing
at the inlet.
The pump is unable to pressurize due to air leak
either at inlet and/or outlet.
Check for hose leakage or any fittings that might
be loose.
14
Programming
Fig. 10