Special Functions; Theft Alarm; To Connect, Set And Operate - Alinco DR-635T Instruction Manual

Special Functions

THEFT ALARM

This alert uses a beep sound when the unit is about to be removed in an improper manner. This
function is useful when the unit is installed in a vehicle.

To connect, set and operate

IMPORTANT: Be sure to connect the power cable directly to the car battery. The power cable of
this unit requires voltage at all times to activate this function.
For the same reason, the ACC ON/OFF feature must be deactivated.
1.
Wire the alarm cable (There are 2 ways to con-
figure).
1. Modifying and inserting a 3.5 Ø stereo plug
for the alarm into the SP terminal jack in
the back, as the figure shows.
This configuration is recommended for ve-
hicle installation, for easier removal of the
cable
2. Modifying and inserting the provided wir-
ing cable UX1290A into the connecter
CN10 in the unit.
This configuration is recommended for a
semi-permanent installation. By selecting
this configuration the speaker remains ac-
tive, either internal or external, as config-
ured.
2.
Be sure to fix the alarm cable to the steer-
ing wheel. As the figure shows.
Steering wheel of the car.
Transceiver
Ensure the tube of the
cable goes through the
slot on the chassis.
DC power cable
Battery
3.5 Ø stereo plug: Looped
UX1290A: Extended and looped
Connect and loop the red and black lead.
Black Red
CN10
45