Activating The Bt Audio Source; Entering Pin Code For Bluetooth Wireless Connection; Editing Device Name - Pioneer DEH-P65BT Operation Manual

Operating this unit

Activating the BT AUDIO source

You need to activate the BT AUDIO source in
order to use a Bluetooth audio player.
1 Use MULTI-CONTROL to select
BT AUDIO.
2 Press MULTI-CONTROL to turn the
BT AUDIO source on.
# To turn the BT AUDIO source off, press
MULTI-CONTROL again.
# If you turn the BT AUDIO in the initial settings
off, the history of the most recently connected
Bluetooth audio stored in this unit is cleared.
Entering PIN code for Bluetooth
wireless connection
To connect your cellular phone to this unit via
Bluetooth wireless technology, you need to
enter PIN code on your phone to verify the
connection. The default code is 0000, but you
can change this in this function.
! With some Bluetooth audio players, you
may be required to enter to this unit in ad-
vance PIN code of your Bluetooth audio
player, in order to set this unit ready for a
connection from your Bluetooth audio
player.
1 Use MULTI-CONTROL to select
PIN CODE INPUT.
2 Push MULTI-CONTROL up or down to
select a number.
3 Push MULTI-CONTROL left or right to
move the cursor to the previous or next po-
sition.
4 After inputting PIN code (up to 16 di-
gits), press MULTI-CONTROL to store in this
unit.
# Pushing MULTI-CONTROL right in the confir-
mation display returns you to the PIN code input
display, and you can change the PIN code.
# If an invalid character has been entered, sub-
sequent characters are not displayed.
# If an invalid character has been entered in the
beginning, PIN code cannot be stored in mem-
ory.

Editing device name

You can edit the device name.
The device name is set to PIONEER BT UNIT
as default.
1 Use MULTI-CONTROL to select
EDIT DEVICE NAME.
2 Press DISPLAY to select the desired
character type.
Press DISPLAY repeatedly to switch between
the following character types:
Alphabet—Numbers and symbols
3 Push MULTI-CONTROL up or down to
select a letter of the alphabet.
4 Push MULTI-CONTROL left or right to
move the cursor to the previous or next
character position.
5 Move the cursor to the last position by
pushing MULTI-CONTROL right after enter-
ing the device name.
Push MULTI-CONTROL right again to store
the device name in memory temporarily.
# Pressing MULTI-CONTROL can also store the
device name in memory temporarily. In this meth-
od, cursor doesn't need to be the last position.
# If an invalid character has been entered, sub-
sequent characters are not displayed.
# If an invalid character has been entered in the
beginning, device name cannot be stored in
memory.
Section
02
41
En