Setting The Rear Output And Subwoofer Controller; Switching The Ever Scroll; Activating The Bt Audio Source - Pioneer DEH-P3100UB Operation Manual

Section
04 Initial Settings
2 Press MULTI-CONTROL to turn AUX1/
AUX2 on.
# To turn AUX off, press MULTI-CONTROL
again.
Setting the rear output and
subwoofer controller
This unit's rear output (rear speaker lead out-
put and RCA rear output) can be used for full-
range speaker (REAR SP :FULL/
PREOUT :REAR) or subwoofer
(REAR SP :SUB W/PREOUT :SUB W) connec-
tion. If you switch the rear output setting to
REAR SP :SUB W, you can connect a rear
speaker lead directly to a subwoofer without
using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (REAR SP :FULL). When rear
output is connected to full range speakers
(when REAR SP :FULL is selected), you can
connect the RCA subwoofer output to a sub-
woofer. In this case, you can select whether to
use the subwoofer controller's (low pass filter,
phase) built-in PREOUT :SUB W or the auxili-
ary PREOUT :REAR.
1 Use MULTI-CONTROL to select
SW CONTROL in the initial setting menu.
Refer to Adjusting initial settings on the pre-
vious page.
2 Press MULTI-CONTROL to display the
setting mode.
# Press DISP/BACK/SCRL to return to the pre-
vious display.
3 Use MULTI-CONTROL to select the de-
sired setting.
Press to switch the segment you wish to set
between left and right. Turn to change the set-
ting of each segment.
Left segment
REAR SP
(rear speaker setting)
30
En
Right segment
FULL (full-range speaker)
SUB W (subwoofer)
SUB W (subwoofer)
PREOUT
(RCA output setting)
REAR (full-range speaker)
# When you select REAR SP :SUB W, you can
not set PREOUT (RCA output setting).
Notes
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to Using subwoofer output on page
27).
! If you change this setting, subwoofer output
in the audio menu will return to the factory
settings.
! Both rear speaker lead outputs and RCA rear
output are switched simultaneously in this
setting.

Switching the ever scroll

When Ever Scroll is set to ON, recorded text in-
formation scrolls continuously in the display.
Set to OFF if you prefer the information to
scroll just once.
1 Use MULTI-CONTROL to select
EVER SCROLL in the initial setting menu.
Refer to Adjusting initial settings on the pre-
vious page.
2 Press MULTI-CONTROL to turn the ever
scroll on.
# To turn the Ever Scroll off, press
MULTI-CONTROL again.

Activating the BT AUDIO source

You need to activate the BT AUDIO source in
order to use a Bluetooth audio player.
! You can only operate this function when
Bluetooth adapter (e.g. CD-BTB200) is con-
nected to this unit.